Grizzly G0462 - Manual (Page 18)

-16-
g0462 Wood Lathe (mfg. since 3/10)
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on page 31.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1. make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2. make sure all tools and objects used during
setup are cleared away from the machine.
3. plug the lathe into the power source.
4. Flip the paddle up to turn the lathe ON.
Note: Make sure that your hand stays poised
over the switch in case you need to quickly
turn the machine
OFF.
Before the machine can be connected to the
power source, an electrical circuit must be made
available that meets the minimum specifications
given in the
circuit Requirements on page 9.
if a power circuit has not been prepared for the
machine, do that now. to ensure a safe and code-
compliant setup, we strongly recommend that all
electrical work be done by a qualified electrician.
power connection
6. Attach the digital readout to the top of the
head with the pre-installed phillips head
screws, lock washers, and flat washers, as
shown in
figure 14.
5. Align the quill keyway with the entry hole
of the quill lock lever (see figure 13), then
install the lever into the tailstock so that the
end of it mates with the quill keyway.
Note: Make sure the dog-point end of the
lock lever fits into the quill keyway so that
the quill can move in and out of the tailstock
without rotating.
figure 14. digital readout installed.
x 2
figure 13. Quill lock lever.
Quill
Lock Lever
Quill
Keyway