GE ZKD910 - Manual (Page 12)

Save time
and money!
Review the
troubleshooting
tips on this
page first and
you may not
need to call
for service.
PROBLEM POSSIBLE CAUSE
WARMING DRAWER • A fuse in your home may be blown or the circuit breaker tripped.
WILL NOT WORK Replace the fuse or reset the circuit breaker.
• Warming drawer not plugged in. Plug in.
• Warming drawer controls improperly set. See the Using the
Warming Drawer section.
DRAWER DOES NOT • Ball bearings are out of alignment. Fully extend the drawer and
SLIDE SMOOTHLY push it all the way in. See the Care and Cleaning section.
OR DRAGS
• Drawer over-loaded or load unbalanced. Reduce weight to less than
50 pounds. Redistribute drawer contents.
EXCESSIVE • Liquid in warming drawer. Remove liquid.
CONDENSATION
• Uncovered foods. Cover food with lid or aluminum foil.
• Temperature setting too high. Reduce temperature setting.
• Incorrect Moisture Selector setting. Set the Moisture Selector to
the open vent setting to allow venting.
NO HEAT IN THE • Room temperature may prevent the thermostat from tripping on.
PROOF SETTING Turn the knob to LOW then back to PROOF.
FOOD DRIES OUT • Moisture escaping. Cover food with lid or aluminum foil.
12
Before You Call For Service…
Electric Warming Drawer