Gefen ex-tend-it 4x4 DVI Matrix - Manual (Page 9)

6
IR CODES
In the event of IR confl icts, please do the following:
1. Remove the battery cover from the back of the RMT16-IR remote.
2. Locate the Dip Switches above the batteries
3. Switch the Dip Switches on the RMT16-IR to any of the combinations pic-
tured below.
4. Dip Switches 1 and 2 in the RMT16-IR correspond with Dip Switches 1 and
2 inside the 4x4 DVI Matrix respectively. Switch the switches inside the 4x4
DVI Matrix to match the same Remote Channel as the RMT16-IR. The 4x4
DVI Matrix is now set to a new IR Code.
1 2
Remote Channel 0:
1 2
Remote Channel 1:
1 2
Remote Channel 2:
1 2
Remote Channel 3: