beautypg.com

Care and maintenance, Models with changing table and wheels, Models with wheels only – Graco PACK N PLAY 9046 User Manual

Page 4: Models with feet or casters and feet

background image

5

361-10-99

6

7

HINTS:

!

If top rails do not unlatch, lift

!

the center of the floor higher.

!

Both tubes must be released

!

for the top rail to fold.

Step 4.

Pull center up all the way.

To fold the top rail:

!

Lift up slightly on the top rail.

!

Push up on the button located under

!

the symbol to release the two tubes.

!

Push down.

Step 5.

Gather your unit together.

Do not force.
If unit will not fold, look for a

partially latched top rail. Squeeze

the latch button to release the rail.

Step 6.

Find the bottom corner belt loop

(only one). This loop is for holding

unit and mattress together while

carrying.

Step 7.

Wrap the mattress around your unit.

Fasten together the

VELCRO

®

straps,

attaching the bottom strap to the

bottom corner belt loop.

To Fold Your Pack ’N Play

®

Step 1.

Lower the back flap. Apply

locks on wheels or casters,

if present. Release the two

VELCRO

®

straps under the

Pack ’N Play, and remove the

mattress.

Step 2.

IMPORTANT:

Raise center halfway

BEFORE unlocking

rails.

Grasp the red handle

on the center of the floor

as shown.
Push down and turn

handle. Then pull up

approximately halfway

to the top rails.

To Cover Your Pack ’N Play

®

Models with changing table and wheels:

Pull the cover over your unit

as shown, making sure carry

handle attached to Pack ’N

Play mattress is lined up with

zipper.
Before pulling bag up, insert

folded changing table into the

side opposite the handle as

shown. Pull bag up to cover

end. Zip together.

Models with wheels only:

Turn unit upside down, so that

wheels point up. Pull the cover

over your unit. Make sure carry

handle attached to Pack ’N

Play mattress is lined up with

zipper.
Push the plastic end of the bag

over wheels and feet. Turn unit

over and pull bag up to cover

end. Zip together.

Models with feet or

casters and feet:

Pull cover over your

unit. Be sure carry

handle attached to

Pack ’N Play mattress

is lined up with zipper.

Turn unit over. Pull bag

up to cover end. Zip

together.

On certain models:

The cargo bag opens on either end. Slip the bag over

the Pack ’N Play. Check that the carrying handle

attached to the Pack ’N Play mattress sticks out the

hole in the bag. Zip both ends.

Handle

Wheel

Foot

Handle

To Use as a

Playard/Portable Crib

Place mattress into your unit

with padded side up.
Always use your unit with

mattress installed soft side up.
Slide the two

VELCRO

®

straps

through slots in bottom of Pack

’N Play and fasten to

VELCRO

®

on underside. This will prevent

mattress from moving.
Your Pack ’N Play is ready to

use.

8

At first your Pack ’N Play may be like a new pair of

shoes. You may need to break it in by slightly stretching

the netting and fabric. If the center does not stay down,

place some weight (several books) in the center of the

unit and let it stand overnight.

Step 3.

The top rail has a center piece

with two tubes hidden under the

fabric. The button on the bottom

of the center piece releases the

two tubes when it is pushed up.

Center

piece

Tube

Push UP button

under fabric

CARE AND MAINTENANCE

FROM TIME TO TIME CHECK YOUR PACK ’N

PLAY for worn parts, torn material or stitching.

Replace or repair the parts as needed. Use only

Graco

®

replacement parts.

IF PACK ’N PLAY IS USED AT THE BEACH, you

MUST clean sand off your Pack ’N Play, including

the feet, before packing it into cover. Sand in top

rail lock may damage it.
TO CLEAN PACK ’N PLAY, use only household

soap or detergent and warm water.
TO WASH CARRY BAG AND FITTED SHEET,

machine wash in lukewarm water on delicate

cycle and drip-dry. NO BLEACH.