Graco 8487 User Manual

Page 33

Text mode
Original mode

8.3 Airplane Use

8.4 Accessories

(on certain models)

1. Insert the two prongs

of the cupholder into
the two slots on either
the left or right side of
the seat

2. Push cupholder down

until the clip snaps onto
the bottom of seat

CHECK that cupholder
is secure by pulling on it.

This restraint is certified for use in Motor Vehicles. It is
certified for use in Aircraft ONLY when used with the
built-in harness. When used as a booster without
the harness, this restraint is NOT certified for use
in aircraft because there is no shoulder belt available.

Important points to remember

1. Airlines have some restrictions about the use of

car seats.

2. Install your car seat on an airplane in the same way

it is installed in an automobile with a lap belt (see
Section 6.2.1, Securing the Car Seat in Your
Vehicle with a Vehicle Lap or Lap/Shoulder Belt,
pp. 22-23).

3. Check that the airplane seat belt holds the car seat

securely in place at all times.

Clip