Graco UA105 - Manual (Page 6)

Assembly
Instructions
ASSEMBLY INSTRUCTION 6
F r F ron ont t wh whee eel
2. Lean the stroller backwards with the
front forks pointing up. Infl ate tires before
assembly. Assemble the front wheel as
shown. Tighten the lever on the axle until
it is very close to contacting the fork then
close the lever. 1. Release locking latch.
Unfold the stroller. Make
sure both sides of the
frame lock into place.
Remove foam packing
tubes from rear axle/
brake.
3. Remove foam pack-
ing tubes from rear leg
tubes on the frame. At-
tach rear axle assembly
onto rear leg tubes by
inserting the left side a
little bit and the insert-
ing the right hand side.
Press both of them
together until the spring
loaded buttons click into
place. 4. Remove plastic
packing tubes from the
rear wheel axle. Slide
wheel onto axle and
push until you hear a
click. Make sure it is
properly secure. Push
down on spring Clip if
necessary.