Graco 4460402 - Manual (Page 26)

26
5.1.1 3-Point Harness
1. From back, push harness anchor
buckle back through harness slot.
If necessary, from front, use harness
strap to pull buckle from slot
‹
.
2. Reinsert harness anchor buckle in the
appropriate slot
Œ
.
3. From back, remove harness strap from
harness tightener. If necessary, from front,
use harness strap to pull strap from slot.
4. Reinsert strap in the appropriate slot. Thread
strap through tightener exactly as shown

.
5. SAFETY CHECK:
a) CHECK that straps are not twisted;
b) CHECK that straps are secure: pull on
harness straps from front.
c) CHECK that harness anchor buckle is
snapped flat against back as shown
Ž
.
Harness
tightener
‹
Œ

Ž
Harness anchor
buckle