beautypg.com

Installation preparation, Tools & materials required, Power supply locations – GE Monogram ZGU36N6 User Manual

Page 6

background image

6

Installation Preparation

Professional Gas Cooktops

• Saw
• Measuring tape
• Carpenter’s square
• Pipe and fittings as required.
• Manual gas line shut-off valve.
• Gas pressure regulator (supplied)
• Large flat-blade screwdriver
• Pipe wrench

Tools &
Materials
Required:

• Gas-resistant pipe joint sealant
• 5 foot, 5/8" AGA-certified flexible metal gas

supply line. (Length must comply with local
codes.)
–If required by local codes, use solid pipe

fittings.

Note: Purchase new flexible line. DO NOT
USE OLD, PREVIOUSLY USED FLEXIBLE
LINE.

Gas Supply:
• The natural gas models are designed to

operate at 6" to 14" water column pressure.

• The liquid propane models are designed to

operate at 11" to 14" water column pressure.
A regulator is required at the L.P. source to
provide a maximum of 14" water pressure to
the range regulator.

• These gas cooktops are supplied with 1/2"

NPT female gas connection located at the
left rear corner.

• A minimum 5/8" dia. metal flexible line is

required.
–Use 5-foot long 5/8" flexible metal tubing.
(Length must comply with local codes.)

• For rigid connection, locate the pipe stub

within area shown.

• Install a manual shut-off valve in the gas line,

in an easily accessible location.

Power
Supply
Locations

Electric Supply:
These cooktops must be supplied with 120
volt, 60 Hz., and connected to a individual,
properly grounded branch circuit protected
by a 15 amp circuit breaker or time delay fuse.

The power cord of this appliance is equipped
with a three-prong (grounding) plug which
mates with a standard three-prong grounding
wall receptacle to minimize the possibility of
shock hazard from this appliance.

If the electrical service provided does not
meet the above specifications, it is recom-
mended that a licensed electrician install an
approved outlet.

DO NOT UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG FROM THE POWER CORD.

DO NOT USE AN EXTENSION CORD WITH
THIS APPLIANCE.

Three Prong Receptacle

Receptacle Box Cover Plate

Three Prong Plug

• Locate the electric supply within the area

shown or within reach of the cooktop’s six
foot power cord.

• To avoid tangling cord with items stored in

the cabinet, locate the receptacle on rear
wall, inside the cabinet.

Gas Line
to Cooktop

Locate Gas Supply 2" Maximum
Protrusion From Wall or on Floor 2" From Wall

2"

7" for 36" Models
17" for 48" Models

16"

This manual is related to the following products: