beautypg.com

Emptying the grass catcher bag, Replacing the blades – Global Machinery Company RL 500 User Manual

Page 10

background image

10

3. To safely operate the mower ensure all four wheels are

on the ground and be careful not to loose your footing

or control of the mower. Be very careful when mowing

uneven or rough ground. Keep a firm grip on the handle

bar at all times, always walk, never run with the mower.

4. For healthy growth, grass should not be cut too short.

This can cause damage to the grass and allow weeds to

develop.

5. Vary your cutting pattern from week to week, this will

help to prevent matting and graining of the grass.

6. Before checking a clogged mower deck stop the engine

completely and disconnect the spark plug cover and

then tilt the mower so the air filter side is facing

upwards. Use a stick the clear any clogged material,

never use your hands.

7. Mowing wet grass should be avoided. Wet grass will

clog the mower deck and if it is slippery you may loose

your footing.

8. Always mow across slopes not up and down them. Be

extra careful if the grass is wet as this could cause you

to slip and loose control of the mower.

9. If the ground is to dry, mowing will stir up a lot of

dust which may clog the air filter. In these conditions

it is recommended to water your lawn the day before

mowing.

10. Use the side of the mower as a guide to cut close to

large objects such as a fence or a wall. Be careful

when mowing over obstacles embedded in the lawn

such as sprinkler systems and paving, avoid anything

that sticks up above the surface of the lawn.

11. Avoid mowing over loose stones, gravel and other

landscaping material as this can be picked up by the

mower and flung out causing serious personal injury.

12. If the blades do come into contact with something

or the mower starts to vibrate stop the engine

immediately, remove the spark plug cover and inspect

to see if there is any damage.

Emptying the grass catcher bag

Note.

Before making any adjustment or maintenance

procedures to the mower ensure it is turned off and the

spark plug cover is removed.
1. To remove the catcher, raise the discharge guard, grab

the catcher by the handle and lift it off the bar.

2. Empty the grass from the catcher by holding it vertical,

shake it if necessary to dislodge the full contents.

Grass catcher maintenance
Warning.

Check the catcher bag frequently for damage or

wear, and replace it if worn.
The fabric grass catcher requires air to flow through the

fabric for effective grass collection.
Wash it if necessary to restore the open mesh in the fabric.
Do not leave the fabric bag in direct sunlight, prolonged

sun exposure can cause permanent breakdown of the

material.
Do not leave clippings in the catcher for extended periods.

Replacing the blades

Note.

Before making any adjustment or maintenance

procedures to the mower ensure it is turned off and the

spark plug cover is removed.

Note.

Wear heavy gloves to protect your hands.

1. Tilt the mower back so the spark plug is facing up.

2. Remove the blade disc with a spanner to remove the

central blade bolt first.

3. Remove all 4 single blades including the washer and nuts.

3

2