Graco 7927 - Manual (Page 7)

14 15 16 13 832-6-00
Return the form below with payment to:
GRACO CHILDREN’S PRODUCTS INC.
CUSTOMER SERVICE DEPARTMENT
P.O. BOX 100, MAIN STREET
ELVERSON, PA 19520
Replacement Parts
Instructions for ordering stroller parts:
Complete form below. Your stroller model number MUST
be included on the form to ensure proper replacement
parts. Your model number can be found on a sticker
on the rear leg of your stroller. Payment must
accompany your order.
Parts List:
Front seat ................................
Rear seat .................................
Seat pads (front or rear) ..........
Front wheel assembly .............
(2 wheels per unit)
Rear wheel ..............................
Rear axle .................................
Front tray .................................
Rear arm bar* ..........................
Basket ......................................
Front canopy (with frame) .......
Rear canopy (fabric only) ........
Swivel lock button ....................
* On certain models only.
Price:**
$10.00
$15.00
$18.00
$16.00
$ 8.00 (each)
$ 11.00
$12.00
$10.00
$16.00
$13.00
$15.00
no charge
** Prices subject to change without notice.
Step 1.
Pull back both fold latches
at handle. Begin pushing
handle forward.
Step 2.
Hold stroller frame at base of
front canopy and fold ends
together until storage latch on
side catches automatically.
Stroller will fold more compactly
if tray and front canopy are
removed and front wheels are
facing backwards.
If rear wheels are locked, folded
stroller will stand on its own.
To Remove Seat Pads
Front and rear seat pads can be removed if desired for
cleaning or replacement.
Rear Seat Pad:
Unfasten the four snaps and three hook/loop tabs on each
side, and the two snaps on back as shown. Push crotch
strap and waist belt through slots in pad and remove pad.
IF YOU NEED HELP
If you have any questions or if you need
any part not listed, please call toll-free:
1-800-345-4109
or visit our Internet website, www.gracobaby.com.
HELPFUL HINTS
IF WHEEL SQUEAKS, use a light
oil (e.g., WD-40, 3-in-1, or sewing
machine oil). It is important to get
the oil into the axle and wheel
assembly as shown.
WHEN USING YOUR STROLLER AT THE
BEACH, completely clean your stroller afterward to
remove sand and salt from mechanisms and wheel
assemblies.
CARE AND MAINTENANCE
DO NOT MACHINE WASH SEAT. It should only be
wiped with a mild detergent, taking care not to soak
the material. NO BLEACH.
REMOVABLE SEAT PAD may be machine washed
in lukewarm water on delicate cycle and drip-dried.
NO BLEACH.
TO CLEAN STROLLER FRAME, use only household
soap or detergent and warm water. NO BLEACH.
FROM TIME TO TIME CHECK YOUR STROLLER
for loose screws, worn parts, torn material or stitching.
Replace or repair the parts as needed. Use only
Graco ® replacement parts.
EXCESSIVE EXPOSURE TO SUN OR HEAT could
cause fading or warping of parts.
Step 3.
If your child is already in the safety seat because you
have been using it as a carrier, make sure child is
secured with the harness.
Always secure your child with the
safety seat harness when using the safety seat in
the stroller.
Step 4.
Move the safety seat handle
into the carrying position.
Step 5.
Position the safety seat so
that the mounting notches
fit over the edge of the rear
arm bar or front tray. Push
down on the safety seat until
attachment latch snaps onto
the arm bar or tray.
Step 6.
Slide stroller seat belt
webbing under vehicle belt
hooks on each side of the
safety seat. Tighten stroller
seat belt buckles against
inside of safety seat.
Step 7.
Pull up on safety seat handle to be sure the safety seat
is securely attached to the stroller.
To remove safety seat
from the stroller, remove
stroller seat belts from
vehicle belt hooks,
squeeze release handle
at back of safety seat,
and lift safety seat out
of the stroller.
SHIP TO:
Name
Address
City, State, Zip
( )
Telephone
Check enclosed
(payable to Graco Children’s
Products Inc.)
Charge to credit card:
Visa
MasterCard
Discover
Account #:
Expiration date:
Signature:
Front seat
Rear seat
Seat pads (front/rear)
Front wheel assembly
Rear wheel
Rear axle
Front tray
Rear arm bar
Basket
Front canopy
Rear canopy
Swivel lock button
Subtotal:
Shipping
& handling*: $5.00
6% sales tax
(PA only):
Total:
*$15.00 outside the continental U.S.
Model No.
(required)
Serial No.
(required)
Front Seat Pad:
Unfasten the single snap at each side of seat pad. Push
crotch strap and waist belt through slots in pad, and lift pad
off the seat back.
To replace pads, reverse the above steps.
To Fold Stroller
Before folding,
(1) remove safety seat if in
use; (2) adjust seat backs
to upright position; (3) lock
brakes; (4) fold canopies
and lower front canopy
as shown.