Graco 7927 - Manual (Page 4)

6 7 8 5 832-6-00
Step 3.
Repeat above steps for the other side.
Pull firmly on each wheel assembly to be sure the
wheel assemblies are securely attached.
Step 1.
Before assembling rear axle,
it is necessary to recline the
front seat to protect it while the
stroller is inverted. To recline
the front seat, push back of seat
slightly forward while pulling up
on wire as shown to unlock.
Recline seat back.
Step 2.
Turn stroller over.
Step 3.
To prevent serious injury or death from
choking, remove and immediately discard the plastic
covers on the axle.
Position rear axle assembly as shown, with brake levers
pointing toward rear of stroller.
Step 4.
Push both brackets on until plastic tabs snap into the holes
on the leg tubes.
Pull firmly on each bracket to be sure the brackets are
securely attached.
To Assemble Front Wheels
To Assemble Rear Axle
To Unpack Stroller
Step 1.
Flatten stroller carton to
protect floor.
Release storage latch on front
leg. Open stroller on carton as
shown until latched. Use care
not to pinch fingers.
Be sure frame is latched as
shown before continuing
assembly.
Step 2.
Push footrest down onto tube
beneath it.
Step 3.
At rear of stroller, fasten the
three basket snaps around
basket frame.
Flattened
carton
Snaps
Snap red retainer
into axle groove.
Then snap cap over
red retainer as shown.
Storage
latch
To prevent serious injury or death from
choking, remove and immediately discard the plastic
covers on the front leg pins.
Step 1.
Line up wheel assembly with
pin on front leg as shown.
Plastic snaps inside wheel
mount must be away from pin.
Step 2.
Push wheel assembly onto pin
until it snaps in place.
Spokes toward
inside
Rear axle
Retainer (red)
Wide end
toward wheel
Place one rear wheel, red retainer and white cap on one end
of rear axle in order as shown below. Push red retainer onto
axle BEFORE attaching white cap. Repeat on other side.
Wheel
Cap (white)
Attach AFTER
retainer is on axle
To Assemble Rear Wheels
To Attach Front Tray and Rear Arm Bar
(arm bar on certain models only)
Always secure your child with the seat
belt. The tray and arm bar are not restraint devices.
DO NOT lift the stroller by the tray or arm bar.
Use care when clamping the tray or arm bar on the
stroller with a child in the stroller.
Ensure plastic tray supports
are positioned as low on front
legs as possible. Snap the tray
onto front legs of stroller as
shown. Snap the arm bar onto
the rear armrests. Push down
on tray and arm bar to be sure
they are securely clamped onto
the stroller.
To remove, first pull tab on one
side out and toward you, then
unsnap the other side of the
tray or arm bar.
Tab
Tab
Tray
support
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing,
call Customer Service at 1-800-345-4109
or visit our Internet website, www.gracobaby.com.
THIS PRODUCT REQUIRES ADULT ASSEMBLY .
No tools required for assembly.
Rear axle
Frame
Front wheel
assembly (2)
Rear canopy
(with rear flap)
Rear wheel (2)
Rear arm bar
(on certain models)
Front canopy
(no flap)
Retainer
(2, 1 extra)
Cap
(2, 1 extra)
Front tray