Graco 7825 - Manual (Page 3)

5 767-12-97
To Install Handle (on certain models)
Step 1.
Turn handle brackets
straight up.
Step 2.
Position handle as shown.
Step 3.
Place both sides of handle
into brackets and push down
until latched.
8
Rear axle assembly with brake wire:
Step 1.
Turn stroller over as pictured above.
Step 2.
Position rear axle assembly as shown.
Step 3.
Start sliding both brackets onto leg tubes at the same time.
Step 4.
Push both brackets all the way on until metal buttons snap
into bracket holes on inside of legs.
Step 5.
Pull firmly on each bracket to be sure buttons are snapped
into bracket holes.
6 7
Retainer (2,
1 extra)
Rear wheel (2)
Cap (2,
1 extra)
Front wheel
assembly (2)
Pin (2)
Handle
bent
towards
rear
Handle
bracket
Smooth side of
brackets UP
Button
Rear legs
To Assemble Rear Wheels
Place one rear wheel, red retainer, and white cap on one
end of rear axle in order as shown below. Push red retain-
er onto axle BEFORE attaching white cap. Repeat on other
side.
Wheel
Spokes
toward
inside
Rear
axle
Retainer (red)
Wide end
toward wheel
NOTE: Be sure buttons are securely latched in bracket
holes. Check by pulling firmly up on handle.
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at 1-800-345-4109.
THIS PRODUCT REQUIRES ADULT ASSEMBLY .
No tools required for assembly.
Handle
(on certain
models)
Frame
Swivel lock
button (2)
Step 1.
Snap swivel lock button onto
wheel mount as shown. This
must be done BEFORE pin
is inserted (next step).
Step 2.
Insert pin through hole in
wheel mount. Then push
round end of a front wheel
assembly up onto pin as
shown until it snaps into
place.
NOTE: Check wheel attach-
ment by pulling down on the
front wheel assembly.
Step 3.
Repeat above steps for the
other side.
Insert pin
Push
wheels up
To Assemble Front Wheels
Snap red retainer into
axle groove. Then snap
cap over red retainer
as shown. Be sure cap
is snapped securely
over red retainer.
Cap (white)
Attach AFTER
retainer is
on axle
To Unfold Stroller
Step 1.
Unfold footrest from under
armrest.
Step 2.
Release storage latch.
Step 3.
Unfold as shown.
Be certain
the stroller is fully erected
and latched before allowing
your child near the stroller.
Round
end
To Unpack Stroller
Step 1.
Flatten stroller carton to
protect floor.
Step 2.
Open stroller on
carton as shown
until latched.
Flattened
carton
Latch
Hub cap (2)
(on certain models)
Rear axle
assembly with
brake wire
Rear axle
OR
Rear axle:
Step 1.
Turn stroller over as shown.
Step 2.
Slide the rear axle through the
holes in both axle brackets.
To Assemble Rear Axle
Your stroller will have either a rear axle or a rear axle
assembly with brake wire. Follow the appropriate
instructions below.
Hub cap
(on
certain
models)
Boot