GE 234D1050P001 - Manual (Page 9)

9
About cycle options.
NOTE: Not all features are available on all dryer models . GEAppliances.com
Extended Tumble
Minimizes wrinkles by adding approximately
60 minutes of no-heat tumbling after clothes
are dry . The beeper will sound every two
minutes as a reminder to remove the clothes .
The ESTIMATED TIME REMAINING display will
show 00 .
The Extended Tumble time does not get
added to the cycle time on the display
Damp Alert
This option causes the dryer to beep when
clothes have dried to a damp level . Remove
items that you wish to hang dry . The
DAMP ALERT will only beep when this option
is selected .
Removing clothes and hanging them when
they are damp can reduce the need to iron
some items .
Delay Start
Use to delay the start of your dryer .
1 . Choose your dry cycle and any options .
2 . Press DELAY START . You can increase
the delay time in 1 hour increments using
the DELAY START button .
3 . Press the START pad to start
the countdown .
NOTES:
n If the door is opened while the dryer is
in DELAY START, the countdown time
will not restart unless the door is closed
and START has been pressed again .
e-DRY
Reduces the total energy consumption of
specific dryer cycles by adjusting certain
heat settings .
Note: Cycle times will change when e-DRY is
selected.
This feature can be used with DELICATES,
ACTIVE WEAR, EASY CARE, NORMAL/MIXED
LOADS and COTTONS.
Signal
Alerts you that the cycle is complete .
The beeper will continue to sound every
minute for the next 5 minutes, until the
clothes have been removed . The clothes
should be removed when the beeper goes
off so wrinkles don’t set in .
Press SIGNAL to select low, medium or high
volume, or to turn the beeper off .