GE JKP8627 User Manual

Page 25

Safety Instructions

Operating Instructions

Care and Cleaning

oubleshooting T

ips

Consumer Support

ge.com

Tones at the End of a Timed Cycle

At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds
until the CLEAR/OFF pad is pressed. This
continuous 6-second beep may be canceled.

To cancel the 6-second beep:

Press the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.

Press the KITCHEN TIMER ON/OFF
pad. The display shows CON BEEP
(continuous beep). Press the
KITCHEN TIMER ON/OFF pad
again. The display shows BEEP.
(This cancels the one beep every
6 seconds.)

Press the START pad.

12-Hour, 24-Hour or Clock Blackout

Your control is set to use a 12-hour clock.

If you would prefer to have a 24-hour
military time clock or black out the clock
display, follow the steps below.

Press the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.

Press the CLOCK pad once. The
display will show 12 hr. If this is
the choice you want, press the
START pad.

Press the CLOCK pad again to change
to the 24-hour military time clock. The
display will show 24 hr. If this is the
choice you want, press the START pad.

Press the CLOCK pad again to black out
the clock display. The display will show
OFF. If this is the choice you want, press
the START pad.

NOTE: If the clock is in the black-out mode, you
will not be able to use the Delay Start function.

Cook and Hold

Your new control has a cook and hold feature that
keeps cooked foods warm for up to 3 hours after
Timed Baking or Roasting is finished.

NOTE: This feature can only be programmed to
work with Timed Baking or Roasting. (See the
Using the lower oven timed baking and roasting
features section.) After Timed Baking or Roasting
has automatically stopped, the programmed Cook
and Hold will automatically start.

To activate this feature for use after
Timed Baking or Roasting, follow the
steps below.

Press the BAKE and BROIL HI/LO
pads at the same time for 3 seconds
until the display shows SF.

Press the COOKING TIME pad.
The display will show Hld OFF.

Press the COOKING TIME pad again
to activate the feature. The display
will show Hld ON.

Press the START pad to activate
the cook and hold feature and
leave the control set in this special
features mode.