Global Machinery Company ELC2000 - Manual (Page 5)

5
• Do not use the power tool if the switch does not turn
it on and off. Any power tool that cannot be controlled
with the switch is dangerous and must be repaired.
• Disconnect the plug from the power source before
making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
• Store idle power tools out of the reach of children and
do not allow persons unfamiliar with the power tool
or these instructions to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
• Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tool’s
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
• Use the power tool, accessories and tool bits etc.,
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions and
the work to be performed. Use of the power tool for
operations different from intended could result in a
hazardous situation.
Service
• Have your power tool serviced by a qualified repair
personnel using only identical replacement parts. This
will ensure that the safety of the power tool
is maintained.
Additional safety rules for electric
chain saws
Note. For safety reasons the electric chain saw is
shipped with the chain brake fully engaged. This brake
must be released before the saw becomes operational.
• Never cut into the ground.
• Never cut into wire fences.
• Never cut into samplings.
• Never cut into prepared wood.
• Use the Chainsaw to cut only wood.
• Remove the plug from the mains immediately if the
supply cable is damaged or cut.
• Use the bar cover when moving the electric chain saw
away from the working site.
• During transport the brake must be applied to avoid
accidental start-up.
• Make sure the tool is disconnected when checking,
tigthtening, changing or cleaning the chain.
• Always disconnect the electric chain saw when not in
use, to avoid damage to third persons.
• Do not expose the electric chain saw to rain or windy
conditions or in poor light.
• Find a suitable position before beginning work.
• When working on slopes, the saw operator must stand
beside or above the wood to cut, i.e. felled trees.
• Use the electric chain saw holding it firmly with both
hands.
• Make a wedge-shaped cut before felling the tree, then
the felling cut leaving a hinge for the felling direction.
• Beware of any falling branches after felling operations.
• Beware of wood splinters when cutting chopped wood.
• Ensure your chain saw is suitable for the job.
• Never work above shoulder level or reach out to cut a
branch: ensure you have stable footings at all times.