GIGABYTE GA-K8N-SLI - Manual (Page 49)

BIOS Setup - 49 -
English
2-7 MB Intelligent Tweaker(M.I.T.)
Incorrect using these features may cause your system broken. For power end-user use only.
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
MB Intelligent Tweaker(M.I.T.)
HT Frequency ratio [Auto]
CPU Frequency [200]
K8 CPU Clock Ratio [Auto]
Current DDR speed 266
DDR Clock/ Timing Mode [Auto]
CPU/DDR clock Ratio 2/1.33
DDR Speed 266
x DDR Timing Auto
x CAS# latency (Tcl) 2.5
x Min RAS# active time (Tras) 6T
x RAS# to CAS# delay (Trcd) 3T
x Row precharge Time (Trp) 3T
x Row to Row delay (Trrd) 2T
x Row cycle time (Trc) 9T
x Row refresh cyc time (Trfc) 10T
x Read-to-Write time (Trwt) 4T
x Write Recovery Time (Twr) 2 bus clock
x Wirite-to-Read Delay (Twtr) 1 bus clock
x Refresh Rate (Tref) 133MHz, 15.6 us
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F7: Optimized Defaults
Item Help
Menu Level
HT Frequency ratio
Set HT Frequency ratio to 1x, 1.5x, 2x, 2.5x, 3x, 4x, or 5x. (Default: Auto)
CPU Frequency
200 ~ 456 Set CPU frequency from 200Mhz to 456Mhz.
K8 CPU Clock Ratio
This setup option will automatically assign by CPU detection. The option will display "Locked" and
read only or will not show up if the CPU ratio is not changeable.
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
MB Intelligent Tweaker(M.I.T.)
x Read Preamble value 7ns
x Async Latency value 7ns
CPU Spread Spectrum [Center Spread]
PCIE Clock [100Mhz]
Robust Graphics Booster [Auto]
CPU Voltage Control [Normal]
Normal CPU Vcore 1.500V
Chipset core PCI-E voltage [Normal]
HT-Link voltage control [Normal]
DDR voltage control [Normal]
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F7: Optimized Defaults
Item Help
Menu Level