GIGABYTE GA-K8N-SLI - Manual (Page 41)

BIOS Setup - 41 -
English
On-Chip MAC Lan
Auto Auto-detect onboard LAN chip function. (Default value)
Disabled Disable onboard LAN chip function.
On-Chip LAN BOOT ROM
This function decide whether to invoke the boot ROM of the onboard LAN chip.
Enabled Enable this function. (Default value)
Disabled Disable this function.
NV IDE/SATA RAID function (Note)
Enabled Enable NV IDE/SATA RAID function.
Disabled Disable this function. (Default value)
IDE Primary Master RAID
Enabled Enable 1st master channel IDE RAID function.
Disabled Disable this function. (Default value)
IDE Primary Slave RAID
Enabled Enable 1st slave channel IDE RAID function.
Disabled Disable this function. (Default value)
IDE Secndry Master RAID
Enabled Enable 2nd master channel IDE RAID function.
Disabled Disable this function. (Default value)
IDE Secndry Slave RAID
Enabled Enable 2nd slave channel IDE RAID function.
Disabled Disable this function. (Default value)
NV Serial-ATA 1
Enabled Enable Serial ATA 1 supported. (Default value)
Disabled Disable Serial ATA 1 supported.
NV SATA 1 class code (Note)
0101 Set NV SATA 1 class code to 0101. (Default value)
0104 Set NV SATA 1 class code to 0104.
NV SATA 1 Primary RAID
Enabled Enable 1st SATA primary RAID function. (Default value)
Disabled Disable this function.
NV SATA 1 Secondary RAID
Enabled Enable 1st SATA secondary RAID function.(Default value)
Disabled Disable this function.
NV Serial-ATA 2
Enabled Enable Serial ATA 2 supported. (Default value)
Disabled Disable Serial ATA 2 supported.
(Note) When using driver version 1.2, please enable "NV IDE/SATA RAID function" if you wish to create
RAID data drive or install O.S. on the RAID drive.
And manually set "NV SATA1/NV SATA 2 class code" from 0101 to 0104.
If your SATA hard drive is connected to the SATA0 or SATA1 connector , please set "NV SATA1
class code" to 0104. If your SATA hard drive is connected to the SATA2 or SATA3 connector ,
please set "NV SATA2 class code" to 0104.