Graco ISPA162AB User Manual
Page 77

37
1.
For ease of installation, extend
LATCH to its maximum length
and remove from storage bars.
2.
Position base in vehicle seat as
shown.
3.
Make sure LATCH is through
vehicle/LATCH belt path normally
used for vehicle seat belt. .
Belt must lay flat and not be twisted.
4.
Hook Connectors to vehicle lower
anchors. Pull firmly on Connectors to
be sure they are attached .
5.
Tighten LATCH by pushing down
hard on base and pulling the
adjustment belt .
6.
NEVER put two LATCH connectors
on one vehicle LATCH anchor unless
specifically allowed by the vehicle
manufacturer .
7.
Test infant restraint for secure
installation as described in infant
restraint
“Final Safety Check” page.40.
8.
Check that the LATCH stays tight
and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Graco at 1-800-345-4109.
7.3 Using LATCH to install Base
- 6929 (17 pages)
- 1759207 (36 pages)
- Quattro Tour PD108195A (128 pages)
- ISPA178AB (40 pages)
- ISPA208AA (32 pages)
- LiteRider 6989 (4 pages)
- ISPA003AB (128 pages)
- 4629 (11 pages)
- 1764665 (36 pages)
- 7G10MLB3 (112 pages)
- 7587 (8 pages)
- 6111 (128 pages)
- 6111 (36 pages)
- ISPA173AB (44 pages)
- 7700 (7 pages)
- ISPA003AC (18 pages)
- ISPA005AB (36 pages)
- ISPA010AD (121 pages)
- ISPA118AC (110 pages)
- 1760815 (136 pages)
- ISPA007AA (120 pages)
- ISPA089AE (111 pages)
- 6983 (32 pages)
- 4530 & 4540 (20 pages)
- 6900 (112 pages)
- ISPA041AA (36 pages)
- 6116 (20 pages)
- 7930 (36 pages)
- PD117892A (112 pages)
- ISPA008AA (130 pages)
- ISPA237AA (136 pages)
- ISPA020AB (120 pages)
- 7932 (20 pages)
- ISPA113AB (128 pages)
- 6216 (32 pages)
- Euro 7424 (124 pages)
- Alano ISPA238AB (32 pages)
- 1759724 (40 pages)
- 1750713 (132 pages)
- ISPA109AC 08/05 (36 pages)
- Model Type 7431 (100 pages)
- ISPA114AB (24 pages)
- Graco (36 pages)
- Spree 1761532 (128 pages)
- Alano 1750668 (112 pages)