Global Machinery Company TS1800 - Manual (Page 7)

7
Unpacking
Due to modern mass production techniques, it is unlikely
that your GMC Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate the tool until the
parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
1. Remove all loose parts from the carton.
2. Remove the packing materials from around the saw.
3. Carefully lift the saw from the carton and place it on
a level work surface.
Before using the table saw
1. Turn the table top and body upside down on a piece
of card to protect the table surface.
2. Remove the 6 screws securing the base plate
and take off the base plate.
3. Take out the polystyrene foam around the motor pack
to protect it during transport.
4. Replace the base plate and add the 6 screws.