Stovax PM219 - Manual (Page 24)

INSTALLATION INSTRUCTIONS
24
4. FITTING AN OPTIONAL FLUE
GATHER
4.1 Fitting Of Optional Flue Gather
16" 22" 24" 26" 28"
Flue gather -
standard (central)
- 8658 8659 8660 8661
Flue gather -
staggered (offset)
- 8663 8664 8665 8662
• Place the appropriate flue gather on top of the convector
box, See Diagram 27
27
PR8093
Back of
convector
box
Return
Flange
• Line the inside of the return flange up with the back of
the convector box
• Mark the hole positions on the top of the Convector box
• Drill appropriate holes for a self tapping screw/tapping a
hole
• Secure the gather to the top using chosen fixings (not
supplied)
• Ensure a good seal is achieved with the top of the box by
using either ladder tape or fire cement
5. INSTALLING SOLID FUEL CAST IRON
CONVECTOR
Installation of the fireplace must comply with Building
Regulations relating to heat producing appliances
(Approved Document number J1/2/3). If there is any
conflict between these instructions and the Regulations,
the Regulations shall apply.
5.1 After installing the firebox, Diagram 28
• Ensure the flange of the firebox is appropriately sealed to
the wall
• Slide the 2 ceramic tile sets into the ladders on either side
of the cast iron fireplace (B)
• Secure in place with screws and flat bars provided
Caution: Do not overtighten the bars as this may crack the
tiles.
• Attach the fireplace hood (C) using the threaded studs
and nuts fixed to it
• Apply a continuous band of sealant to the hatched area
on the front of the firebox, see Diagram 28
28
A
B
C
D
F
G
E
H
I
• Lift the cast iron fireplace into position against the front of
the firebox
• Secure it loosely with the nuts and bolts provided through
the two holes (D) below the hood
• Secure the bottom of the fireplace to the firebox using the
2 bolts and brackets supplied, See Diagram 29
29
• Tighten all 4 bolts securely and wipe off surplus sealant
• Slide the base plate (E) into the bottom of the firebox,
slotting it over the lugs on the cast iron fireplace
• Stand the grate (F) on the base plate so it fits tightly
against the back and sides of the firebox