Global Machinery Company RT300 User Manual

Page 10

the adjustable fence bracket.

Secure the bolt with a flat

washer and a large lock knob

(fig. G).

4. Feed the medium carriage bolt

through the channel opening

on the left side of the table and

through the opening on the left

side of the fence. Secure the

bolt with a flat washer and a large lock knob.

Attaching the infeed and outfeed fence

1. Place one sliding panel along

the front side of the fence and

align the channel openings on

the panel with the holes along

the front of the fence.

2. Place a small carriage bolt

through each of the two

openings on the front of the

panel and secure each bolt

with a flat washer followed by a small lock knob (fig. H).

3. Repeat steps 1 and 2 to secure the second sliding panel

to the fence.

Attaching the guard to the fence

The guard (13) protects the operator from the cutting edge

of the router bit. A pin secures the guard to a support on

the fence. The guard will move freely when it is attached

properly to the fence.
1. Place the arm of the guard

(13) over the support base on

the fence (7) (fig. I).

2. Align the openings on each

side of the guard arm with the

openings on the support base

on the fence.

3. Slide the guard pin through

both sides of the guard arm

and the support base on the

fence (fig. J). Tap gently on

the pin if needed to insert it

through the support base.

Adjusting the mitre gauge

1. Place the mitre gauge bar into

the channel that runs

the full length of the table.

The bar should run freely

in this channel (fig. K).

2. To change the angle of the

mitre gauge (14) loosen the

mitre gauge lock knob (15)

and move the gauge to the

desired angle.

3. Tighten the lock knob to set the gauge at the selected angle.

Mounting an R1200 router

The router plate supplied has

been designed to suit the

GMC R1200, R1250, R2050,

MAG1500R and MAG2050R

routers.
1. If the router plate is attached

to the table remove it by

loosening the 4 screws (fig. L).

2. Secure the router to the router

plate using 3 x M6 countersink

cross head screws (1 x 12mm

(for the blind hole), 2 x 16mm)

(fig. M).

3. Once the router is secured to

the router plate place it under

the table.