GE JGRS06 - Manual (Page 12)

12
Operating Instructions
Safety Instructions
Consumer Support
Tr
oubleshooting T
ips
Using the oven.
Automatic Ignition
The oven burner is lit by electric ignition.
To light the burner, do the following:
Touch the pad for the desired function.
Then touch the + or – pads until the
desired temperature is displayed. The
burner should ignite within 60 seconds.
After the oven reaches the selected
temperature, the oven burner cycles off
completely, then on with a full flame to
keep the oven temperature controlled.
Before you begin…
Look at the controls. Be sure you
understand how to set them properly.
Check the oven interior. Look at
the shelves. Take a practice run at
removing and replacing them
properly to give sure, sturdy support.
Read over the information and tips
that follow.
Keep this manual handy so you can
refer to it, especially during the first
weeks of using your new oven.
NOTE: You may notice a “burning” or “oily”
smell the first few times you turn your oven
on. This is normal in a new oven and will
disappear in a short time.
Power Outage
The oven burner will not light in the event
of an electrical power outage.
CAUTION: Do not attempt to light it manually
with a match.
Oven Vent
When the oven is on, heated air moves
through a vent behind the grille.
The vent area could get hot during
oven use.
The vent is needed for proper air flow in
the oven and good baking results. Do not
block this vent. Doing so may cause oven
failure or fire.
Oven Light
Touch the OVEN LIGHT pad to turn the light
on or off.