Gossen MetraWatt 702 - Manual (Page 46)

46 GOSSEN METRAWATT GMBH
19 Maintenance - Calibration
Housing Maintenance
No special maintenance is required for the housing. Keep outside
surfaces clean. Use a slightly dampened cloth for cleaning. Avoid the
use of cleansers, abrasives or solvents.
Calibration
According to the new DIN VDE 0702:2004-06 standard the following ap-
plies as from 1/6/2004:
„Measuring instruments used for periodic testing must be inspected and
calibrated at regular intervals.“
Please contact us to fix an appointment for the inspection and calibration
of your test instruments: GOSSEN METRAWATT Calibration Center,
Phone 0911-8602-256, address see below.
Device Return and Environmentally Compatible Disposal
The instrument is a category 9 product (monitoring and control instru-
ment) in accordance with ElektroG (German Electrical and Electronic De-
vice Law). This device is not subject to the RoHS directive.
We identify our electrical and electronic devices (as of
August 2005) in accordance with WEEE 2002/96/EG
and ElektroG with the symbol shown to the right per
DIN EN 50419 .
These devices may not be disposed with the trash.
Please contact our service department regarding the
return of old devices.
20 Repair and Replacement Parts Service
DKD Calibration Laboratory* and Rental Instrument Service
If required please contact:
GOSSEN METRAWATT GMBH
Service Center
Thomas-Mann-Str. 20
90471 Nürnberg, Germany
Phone: +49-(0)-911-8602-0
Fax: +49-(0)-911-8602-253
E-mail: [email protected]
This address is only valid in Germany.
Please contact our representatives or subsidiaries for service in other
countries.
* Calibration Lab for Measured Electrical Quantities: DKD – K – 19701
Accredited per DIN EN ISO/IEC 17025
Accredited quantities: direct voltage, direct current value, direct current resistance,
alternating voltage, alternating current value, AC active power, AC apparent power,
DC power, capacitance, frequency