GE 25893 - Manual (Page 16)

16
3. Press program to confirm.
NOTE: Press the EXIT button once to keep the previous setting and return
to the standby screen.
NOTE: To restore the default setting to - - - , press delete/answerer when
SET AREA CODE shows in the display.
T
ONE
/P
ULSE
Most telephone systems use tone dialing, however, some may still use
pulse dialing. This system is pre-set to tone dialing. Depending on your
service type, set the dialing mode as follows:
1. Press the program button until SET TONE/PULSE shows in the display.
The default dialing mode is TONE.
2. Use the CID/VOL left (-) or right (+) arrow button or the handset touch-
tone pad to enter your selection.
3. Press program to confirm.
NOTE: Press the EXIT button once to keep the previous setting and return to
the standby screen.
F
ACTORY
D
EFAULT
As you become familiar with this system, you may prefer to use the
system’s original settings. Follow the steps below to return to the factory
default settings.
1. Press the program button until DEFAULT SETTING shows in the display.
The default is 2 NO.
2. Use the CID/VOL left (-) or right (+) arrow button or the handset touch-
tone pad to select 1 YES or 2 NO.
3. Press program to confirm.
NOTE : The default settings are ENGLISH, LOCAL AREA CODE - - -, and TONE.
NOTE : Press the EXIT button once to keep the previous setting and return to
the standby screen.