beautypg.com

GE DCVH640 User Manual

Page 12

background image

12

Operating

Instructions

Safety

Instructions

Consumer

S

uppor

t

Tr

oubleshooting

Tips

Reversing the door swing.

STEP-BY-STEP INSTRUCTIONS (cont.)

Remove Door Assembly

2. Open the door to approximately 90 degrees. Remove the 4 screws starting

from the bottom to the top. Make sure the door is supported while removing
the screws.

3. Loosen the top screw as shown. Unhook the door by lifting and pulling as

shown by the arrows.

4. Lay the door down on a soft protected flat surface so that the inner part faces

upward (door resting on the handle side).

5. Remove the 6 large tapping screws (#10) located around the perimeter

of the door outlining the gasket, and the 2 machine screws (#8) on the hinge
side.

6. With the screws removed, turn the door over and separate the silver cover part

of the door from the door frame and set aside.

7. Unlock the 4 tabs on the plastic cover and separate the plastic cover from

the frame.

NOTE: Disregard the “DO NOT REMOVE” label on the plastic cover.

6 #10
Large
Screws

2 #8
Machine
Screws

2 #8 Machine Screws

Remove the
four screws

This manual is related to the following products: