GE 26993 - Manual (Page 6)

6
D
ESKTOP
I
NSTALLATION
1. Make sure the mounting bracket is securely fastened.
2. Set the TONE/PULSE switch to TONE for touch-tone service, or PULSE
for rotary service. If you don’t know which type of service you have,
check with the phone company.
3. Set RINGER switch (on the handset) to ON.
4. Plug the power supply cord into the POWER 9V DC jack on the base and
into an AC outlet.
5. Place handset in the base to charge for 12 hours. The CHARGE indicator (on
the base) comes on to indicate that the battery is charging. If you don’t
charge the handset battery properly (for 12 hours) when you first set
up the phone, performance of the battery will be compromised.
6. Plug the long telephone line cord into the TEL LINE jack on the base
and into a modular jack.
7. Raise the base antenna.
CAUTION: Use only the Thomson 5-2472(black)/5-2471(white) power supply
that came with this unit. Using other power supplies may damage the unit.
INSTALLATION NOTE: Some cordless telephones operate at frequencies that
may cause interference to nearby TVs and VCRs. To minimize or prevent such
interference, the base of the cordless telephone should not be placed near or on
top of a TV or VCR. If interference continues, moving the cordless telephone
farther away from the TV or VCR will often reduce or eliminate the interference.
TONE/PULSE
switch
5
3
2
7
1
4
6