Troubleshooting – Global Machinery Company LDP13F12 User Manual
Page 16

16
Troubleshooting
Warning.
Turn the on/off switch to the off position and
unplug the tool from the power supply before performing
trouble shooting procedures.
Troubleshooting
Problem
Cause
Solution
Drill press will not start
Power cord not plugged in
Ensure that the cord is connected to the
power supply
Power fault, fuse or circuit breaker tripped
Check the power supply
Cord damaged
Use authorised service centre to repair or
replace
Faulty switch
Use authorised service centre to repair or replace
Faulty motor
Use authorised service centre to repair or
replace the motor
Noisy operation
Incorrect belt tension
Adjust tension as required
Drill bit burns
Incorrect speed
Change speed, refer to the “Changing the
speed” section
Chips not coming out of hole
Retract drill bit frequently to clear holes
Dull drill bit
Resharpen or replace drill bit
Excessive drill bit wobble
Bent drill bit
Replace with new drill bit
Drill bit not properly installed in chuck
Install drill bit properly and ensure it is secure
Chuck not properly installed
Install chuck properly
Wood splinters under workpiece
No “packing” material below workpiece
Use “packers” below the workpiece
Workpiece torn from hand
Workpiece not supported or clamped properly
Support the workpiece or clamp it
Drill bit binds in workpiece
Improper belt tension
Adjust the belt tension