Global Machinery Company LDP13F12 - Manual (Page 13)

13
5. Lift the handle up and then
proceed with the drilling
operation.
6. To disable the depth lock
loosen the handle screw and
rotate the depth scale to the
maximum depth.
7. Tighten the handle screw
firmly to secure the handle in
position.
Changing the speed
Caution. Always ensure that the drill press is switched
off and the plug is removed from the power point before
making any adjustments.
The speed of the drill press is determined by the size of the
pulley steps that the belt is attached to. Using a smaller
pulley step on the front pulley means a faster drill speed;
using a larger pulley step on the front pulley means a
slower drill speed. The below table indicates the speed of
the drill in the various belt positions.
1. Remove the plug from the mains socket.
2. Take off the pulley cover.
3. Loosen the motor and reduce
the belt tension by pulling
the belt tension lever towards
the motor and pushing motor
forwards.
4. To select a faster drill speed,
move the belt up to a higher
step on the front and central
pulleys and lower step on
the central and rear pulleys.
Rotating the pulleys and
“rolling” the belt onto the
larger pulley will make this
easier.
5. To select a slower drill speed,
move the belt down to a
smaller step on the front and
central pulleys and a higher
step on the central and rear pulleys. Rotating the pulleys
and “rolling” the belt onto the larger pulley will make
this easier.
6. To tighten the belts on
the pulleys pull the motor
backwards. This is best done
by grabbing hold of the top
of the rear pulley and the
bottom of the motor housing.
7. Rotate the pulley by hand to
ensure everything is aligned
and correct.
8. Replace the pulley cover.
040611 LDP13F labels ED6 JJ
1
2
0
in
3
6
5
4
2
0
1
mm
• Improved Drilling Vision Ł
• Faster Set-up
• Increased AccuracyŁ
• Safer Working Ł
Environment
REDEYE
®
Rack & Pinion
12 SPEED
DRILL PRESS
REDEYE
®
1280 1600 1790 2470
530 580 1030 1160
230 330 370 460
LASER LIGHT. LASER RADIATION
Do not stare into beam.
Only turn laser beam on when tool
is on work piece. Class 1 laser product
• 13mm Keyless Chuck
• Depth Gauge
• Side Extension Ł
Tables
• Cast Iron Base,Ł
Table and Head
1/2 HP
LDP13F Drill Press with Laser Line
230V–240Vac ~ 50Hz 375W n o. 230–2470 RPM
Ø13mm EARTHED APPLIANCE
Always wear ear and eye protection. If cordset is damaged
have it replaced by an authorised service centre.
Help Line 1300 880 001 (Aus) or 0800 445 721 (NZ)
Product of China to GMC Quality Standards
45º40º 30º 20º 10º 0º 40º45º 30º 20º 10º
60
50
40
30
20
2
0
in
1
10
0
mm