Genie DirectLift 3060 - Manual (Page 8)

8
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
A To program one Button of a Remote Control (Figure MA-4):
• Locate Learn Button and Learn Indicator Light
on left side of Power Head (Figure MA-5) .
• Press and release Learn Button . Red Learn
Indicator Light will blink 2 times per second .
• Press Remote Control Button once within 30
seconds . Red Learn Indicator Light will stay lit .
• Press Remote Control Button again . Red Learn
Indicator Light will go out, indicating that
memory is stored .
B Program each additional Remote using step A above
(up to seven) .
NOTE
• Each Remote Control must be programmed
separately .
• The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning .
• When programming the Remote Controls, they
must be at least 24” from the Antenna Wire .
• If the red Learn Indicator Light blinks
approximately 4 times per second,
programming has stopped . If programming
has stopped, repeat the above steps .
• Each Button on a 2 or 3 Button Remote Control
is for a different Opener . You cannot use more
than one Button per Remote, per Opener .
• A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time . If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see “To Erase All
Receiver Memory .”
C p
RoGRamminG the
R
emote
C
ontRolS
Programming 1:
a
CCeSSoRieS
To Erase All Remotes from Power Head Memory
A Press and hold Learn Button on Power Head for 10
seconds or until Learn Indicator Light goes out .
Memory is erased:
• Program Transmitter/Receiver again as needed .
To Replace Remote Control Battery
A FOR NON-FLASHLIGHT MODELS
• Pop off the back of the transmitter .
– Use coin, pen, screwdriver or any similar device .
– Replace old Battery with new coin type battery .
• Replace back of remote.
B FOR FLASHLIGHT MODELS
• Slide open battery cover .
– Replace old Battery with new AAA battery .
• Replace battery cover.
A Open garage door using
Wall Console .
B Lay a 2” x 4” board flat in center
of doorway .
C Close door using Wall Console .
D Check that door stops and reverses
within 2 seconds after it
contacts board:
• If door does not reverse, decrease
Close Force until door reverses .
• If door still does not reverse,
move Limit Switch toward door .
E Check Safe-T-Beam® System
operation:
• If beam is blocked, door will
not close .
NOTE
The door must contact the 2” x 4” board before the Carriage activates
the Close Limit Switch . If not, readjust the Close Limit Switch .
C
h S
ettinG
C
ontaCt
R
eVeRSe
f
unCtion
Adjustment 2:
NOTE
Limit Switch and Force Adjustments must be completed
before checking the contact reverse function (Figure MA-3) .
2” x 4” board
laid flat
Figure MA-3
Transmitter Compliance Statement