Grizzly G0622 - Manual (Page 26)

-24-
Model G0622 (Mfg 2/08+)
Blade Guides
the blade guides should be as close to the
workpiece as possible. this will help ensure
straight cuts by keeping the blade from twisting
and drifting off the cut line.
To adjust the blade guides:
1. diSConneCt BAndSAW FroM poWer!
2. loosen the knob shown in figure 30 and slide
the blade guide as close to the workpiece as
possible, then re-tighten the knob.
the feed rate is controlled by the spring and
handle shown in
figure 31.
To adjust the feed rate:
Slower: twist the handle clockwise to add ten-
sion to the spring.
faster: twist the handle counterclockwise to
remove tension from the spring.
feed Rate
figure 30. Blade guides.
Blade guides
Knob
figure 31. Feed rate adjustment.
Spring
handle