GE 29897 User Manual

Page 7

NSTALLING

THE

HONE

ESKTOP

NSTALLATION

1. Plug the coiled cord into the handset. Plug the other end into the jack on the side of the base.

2. Place the handset in the base.

3. Plug the telephone line cord into the LINE jack on the back of the phone. Plug the other

end into a wall jack.

4. Connect the small end of the power supply into the POWER 7.5V AC jack on the back of

the answerer. Plug the other end into an AC power outlet. The unit beeps once and is
ready for setup or to answer calls with the default greeting and settings.

NOTE:

The phone automatically defaults to touch-tone dialing. To change to pulse

(rotary) dialing, see “Setting the Dialing Mode.” If you don’t know which type of service
you have, check with the phone company.

NOTE:

The unit is properly installed if you pick up the handset and hear the dial tone.

Otherwise, recheck all the installation steps.

CAUTION:

Only use the ATLINKS USA 5-2644 power supply that is packed with

this unit. Using other power supplies may damage the unit.