GE 200D8074P044 - Manual (Page 9)

9
Consumer Support
Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
About the refrigerator doors.
GEAppliances.com
Refrigerator Doors
The refrigerator doors may feel different
than the ones you are used to. The special
door opening/closing feature makes sure the
doors close all the way and are securely
sealed.
When opening and closing the door you will
notice a stop position. If the door is opened
past this stop point, the door will remain
open to allow you to load and unload food
more easily. When the door
is only partially open, it will automatically
close.
The resistance you feel at the stop
position will be reduced as the door
is loaded with food.
When the door is only partially open,
it will automatically close.
Beyond this stop the door will
stay open.
Door Alignment
If doors are uneven, adjust the refrigerator
door.
Using a 7/16” socket wrench, turn the
door adjusting screw to the right to raise
the door; to the left, to lower it. (A nylon
plug, imbedded in the threads of the
pin, prevents the pin from turning
unless a wrench is used.)
After one or two turns of the wrench,
open and close the refrigerator door
and check the alignment at the top of
the doors.
To remove the base
grille, open the doors,
remove the screw at
each end of the base
grille and then pull
the grille straight out.
7/16” Socket Wrench
Raise
Support Leg
Before moving the refrigerator, you will need
to screw up the support leg. Once the unit is
relocated, you will need to screw down the
support leg again.
Screw down the support
leg until it touches the
floor. This will prevent
door misalignment.