beautypg.com

Installation instructions, Connect the tubing to the valve, Flush out the tubing – GE 200D8074P044 User Manual

Page 27: Fasten the shutoff valve, Tighten the pipe clamp, Route the tubing

background image

27

Place the compression nut and ferrule

(sleeve) for copper tubing onto the end

of the tubing and connect it to the

shutoff valve.
Make sure the tubing is fully inserted

into the valve. Tighten the compression

nut securely.
For plastic tubing from a GE

SmartConnect

Refrigerator Tubing kit,

insert the molded end of the tubing into the

shutoff valve and tighten compression nut

until it is hand tight, then tighten one

additional turn with a wrench.

Overtightening may cause leaks.

NOTE:

Commonwealth of Massachusetts

Plumbing Codes 248CMR shall be adhered

to. Saddle valves are illegal and use is not

permitted in Massachusetts. Consult with

your licensed plumber.

CONNECT THE TUBING
TO THE VALVE

7

Saddle-Type
Shutoff Valve

Compression Nut

Packing Nut

Outlet Valve

Ferrule (sleeve)

Turn the main water supply on and flush

out the tubing until the water is clear.
Shut the water off at the water valve after

about one quart (1 liter) of water has been

flushed through the tubing.

FLUSH OUT THE TUBING

8

Installation Instructions

SmartConnect

Tubing

Fasten the shutoff valve to the cold water

pipe with the pipe clamp.

NOTE:

Commonwealth of Massachusetts

Plumbing Codes 248CMR shall be adhered

to. Saddle valves are illegal and use is not

permitted in Massachusetts. Consult with

your licensed plumber.

FASTEN THE SHUTOFF VALVE

4

Tighten the clamp screws until the sealing

washer begins to swell.
NOTE:

Do not overtighten or you may

crush the tubing.

TIGHTEN THE PIPE CLAMP

5

Pipe Clamp

Vertical Cold Water Pipe

Saddle-Type
Shutoff Valve

Washer

Inlet End

Pipe Clamp

Clamp
Screw

Route the tubing between the cold water

line and the refrigerator.
Route the tubing through a hole drilled in

the wall or floor (behind the refrigerator or

adjacent base cabinet) as close to the wall

as possible.

NOTE:

Be sure there is sufficient extra

tubing to allow the refrigerator to move

out from the wall after installation.

ROUTE THE TUBING

6

To complete the installation of the refrigerator,

go back to Step 1 in Installing the Refrigerator.