GE 225D1804P001 - Manual (Page 20)

Installation Instructions
REMOVE THE FRESH FOOD
DOOR HANDLE
(For placement in the installation location or
reversal of the handles – on some models)
Stainless steel (on some models):
REMOVING THE
DOOR HANDLE:
Loosen the set
screws with the
3/32
″ Allen wrench
and remove the
handle. NOTE: For
Double Door models,
follow the same
procedure on the
opposite door.
Plastic handle (on some models):
REMOVING THE DOOR HANDLE: Depress the tab on
the underside of the handle and slide the handle up
and off of the mounting fasteners.
REVERSING THE
DOOR HANDLE
(on some models):
• Remove the
handle mounting
fasteners with a
1/4
″ Allen wrench
and transfer the
handle mounting
fasteners to the
right side.
• Remove the
logo badge.
• Remove and
transfer the plug
button to the left
side of the fresh food door. NOTE: Use a flat plastic
edge to prevent damaging the door. Remove any
adhesive on the door with a mild detergent. Remove
the paper covering on the adhesive backing on the
logo badge prior to carefully attaching the badge to
the door.
A
A
6
A
B
A
B
Mounting
Fasteners
Mounting
Fasteners
Badge
Badge
(appearance may vary)
(appearance may vary)
REMOVE THE TOP AND BOTTOM
FREEZER DRAWER HANDLES
Stainless steel and plastic handles:
Loosen the set screws located on the underside of
the handle with the 1/8
″ Allen wrench and remove
the handle.
NOTE: If the handle mounting fasteners need to be
tightened or removed, use a 1/4
″ Allen wrench.
A
7
A
20
INSTALLING THE REFRIGERATOR
(cont.)
A