beautypg.com

Preparing to install the refrigerator, Installation refrigerator instructions, Models 21 and 25 double freezer drawers – GE 225D1804P001 User Manual

Page 15: Important

background image

Installation

Refrigerator

Instructions

Models 21 and 25

Double Freezer Drawers

Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com

In Canada, call 1.800.561.3344 or Visit our Website at: www.geappliances.ca

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT

Save these instructions for local

inspector’s use.

IMPORTANT

Observe all governing codes and

ordinances.

Note to Installer – Be sure to leave these instructions with

the Consumer.

Note to Consumer – Keep these instructions for future

reference.

Skill level – Installation of this appliance requires basic

mechanical skills.

Completion time – Refrigerator Installation

20 minutes

Water Line Installation
30 minutes

Anti-Tip Bracket Installation
20 minutes

• Proper installation is the responsibility of the installer.

• Product failure due to improper installation is not covered

under the Warranty.

PREPARATION

MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway, the
refrigerator door and freezer drawer can be removed.
• To remove the refrigerator door, see Step 1 in the

Reversing the Door Swing section.

• To remove the freezer drawer, see the Removing the

Freezer Drawer section.

WATER SUPPLY TO THE ICEMAKER AND DISPENSER
(ON SOME MODELS)
If the refrigerator has an icemaker, it will have to be
connected to a cold water line. A GE water supply kit
(containing tubing, shutoff valve, fittings and instructions)
is available at extra cost from your dealer, by visiting our
Website at ge.com (in Canada at www.geappliances.ca)
or from Parts and Accessories, 800.626.2002 (In Canada
1.888.261.3055).

TOOLS YOU MAY NEED

Adjustable Wrench

1/4

″ Outer Diameter

Compression Nut

and Ferrule (sleeve)

(icemaker models only)

Phillips Head Screwdriver

15

3/8

″ and 5/16″ Socket

Ratchet/Driver

3/32

″, 1/8″ and 1/4″ Allen

wrenches

MATERIALS YOU MAY NEED

(not included)

Pencil

1/8

″ Drill Bit and

Electric or Hand Drill

Tape measure

1/4

″ Nut Driver

Lag Bolts

Anchor Sleeves

For Anti-Tip Bracket Mounted on CONCRETE Floors Only

Drill Bit Appropriate for Anchors

Wire Cutters

Level