Fujitsu Siemens Computers V40-1 - Manual (Page 42)

MYRICA V40-1
40 - English A26361-K1070-Z120-1-M119, edition 1
Troubleshooting
Should an error occur, first check the following points. If the distortion is still not eliminated, the LCD
TV should, if possible, be checked on another signal source and/or with another data cable.
If you are unable to solve the problem, please inform our help desk.
Having this problem? Check the following points:
No display (power indicator does not light) ► Check whether the power cable of the
device is properly plugged in and the
ON/OFF switch on the back of the device
is switched on.
Display becomes darker The phosphorous illumination has a limited
lifetime. If your screen display should become
too dark, it will have to be exchanged.
►
Please contact our help desk.
Permanently unlit or lit pixels The standard of production techniques today
cannot guarantee an absolutely fault-free
screen display. A few isolated constant lit or
unlit pixels may be present. The maximum
permissible number of this kind of defective
pixels is dependent on the resolution:
6L / 10D / 10T
L = light, D = dark, T = total
No picture (power indicator glows orange) ► Switch on the TV on the device or with
the remote control.
► Check the setting of the picture signal
source.
The remote control does not work. ► Check whether the batteries in the remote
control are still sufficiently charged.
► Make sure that the sensor for the remote
control on the LCD TV is not exposed to
strong light.