Removing and installing the battery, Removing and installing memory modules – Fujitsu Siemens Computers AMILO Pro V2035 User Manual
Page 60
Removing and installing components during servicing
50
A26391-K183-Z121-1-7619, edition 1
Removing and installing the battery
i
How to remove and reinstall a battery is described in chapter "Using your notebook", in the
section "Removing and installing the battery".
Removing and installing memory modules
If you are asked by the Hotline/Help Desk to remove and install the memory modules yourself,
proceed as follows:
!
Please take note of the safety information in the "Important notes" chapter.
The notebook must be switched off when installing/removing the memory modules, it
must not be in Suspend mode.
Use only memory module which have been released for your notebook.
Do not use force when installing or removing a memory module.
Make sure that foreign objects do not fall into the memory module compartment.
The memory modules are located in a larger service compartment. You must open the entire service
compartment when removing and installing a memory module. Once you have removed the cover,
the various components are exposed. These components should be removed and replaced only by
authorised specialists. Therefore, be sure to observe the following:
!
Individual components (e.g. the processor heat sink) can become very hot during
operation. Therefore, we recommend that you wait one hour after switching off the
notebook before removing or installing the memory modules. Otherwise, there is a danger
of being burned!
As some components with ESDs are exposed, please observe the section "Notes on
installing and removing components".
►
Switch the notebook off.
►
Close the LCD screen so that it locks into place.
►
Unplug the mains adapter from the mains socket.
►
Disconnect all cables connected to the notebook.
►
Turn your notebook over and place it on a stabile, sturdy, flat surface. If necessary, lay an anti-
slip cloth on this surface to prevent the notebook from being scratched.
►
Remove the battery (see "Using your notebook" – "Removing and installing the battery").