Fujitsu Siemens Computers AMILO Pro V2035 - Manual (Page 73)

Troubleshooting and tips
A26391-K183-Z121-1-7619, edition 1 63
The external monitor's power cable or data cable is not connected properly
►
Switch off the external monitor and the notebook.
► Check whether the power cable is plugged properly into the external monitor and into the power
socket.
► Check whether the data cable is properly connected to the notebook and the external monitor
(if it is plugged in with a connector).
► Switch on the external monitor and the notebook.
The external monitor is blank or the image is
unstable (under Windows)
The wrong external monitor has been selected or the wrong screen resolution has been set for the
application programme.
►
End the application programme under Windows with Alt + F4 . If the fault continues to occur
after ending the programme, switch over to the notebook's internal LCD screen with Fn +
F3 . Change the following setting:
► Select the correct monitor or set the correct screen resolution.
–
Setting the screen resolution: Select Start - (Settings) - Control Panel - Display - Settings and
then the screen resolution you require in the Resolution field.
– Selecting the monitor: Select the correct monitor under Start - (Settings) - Control Panel -
Display - Settings - Advanced Properties - Monitor - Modify.
The notebook cannot be started
The battery is not installed correctly.
►
Switch the notebook off.
► Check whether the battery is installed correctly in its compartment.
► Switch the notebook on.
The battery is dead.
►
Charge the battery.
or
►
Install a charged battery.
or
►
Connect the notebook via its mains adapter to the mains outlet.
The mains adapter is not connected correctly.
►
Switch the notebook off.
► Check whether the mains adapter is connected correctly to the notebook.
► Check whether the power cable is plugged properly into the mains adapter and into the mains
outlet.
► Switch the notebook on.