Freud Tools FT3000VCE - Manual (Page 5)

4
SAFETY
WARNING: Read and understand all instructions. Failure to follow all instructions listed below
may result in electric shock,fire, and/or serious personal injury.
SAVE THESE INSTRUCTIONS
GENERAL SAFETY RULES
1. Work Area
a) Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents
which could result in personal injury.
b) Do not operate power tools in explosive atmospheres, such as in the presence of flammable
liquids, gases, or dust. Power tools create sparks which may ignite the dust of fumes.
c) Keep bystanders, children, and visitors away while operating a power tool. Distractions can
cause you to lose control.
2. Electrical Safety
a) Double Insulated tools are equipped with a polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install a
polarized outlet. Do not change the plug in any way. Double Insulation eliminates the need
for the three wire grounded power cord and grounded power supply system.
b) Prevent body contact with grounded surfaces such as pipes, radiators, ranges, and
refrigerators. There is an increased risk of electric shock if your body is grounded.
c) Do not expose power tools to rain. Do not use power tools in damp or wet locations. Water
entering a power tool will increase the risk of electric shock.
d) Do not abuse the cord. Never carry the tool by the cord or yank the cord to pull the plug
from a receptacle. Keep cord away from heat, oil, sharp edges, or moving parts. Replace
damaged cords immediately. Damaged cords increase the risk of electric shock.
e) When operating a power tool outside, use an outdoor extension cord marked "W-A" or "W".
These cords are rated for outdoor use and reduce the risk of electric shock.
3. Personal Safety
a) Stay alert, watch what you are doing and use common sense when operating a power tool.
Do not operate a tool while you are tired or under the influence of drugs, alcohol, or
medication. A moment of inattention while operating power tools may result in serious
personal injury.
b) Dress properly. Do not wear loose clothing or jewelry. Wear protective hair covering to
contain long hair. Keep your hair, clothing, and gloves away from moving parts. Loose
clothes, jewelry, or long hair can be caught in moving parts. Rubber gloves and non-skid
footwear are recommended when working outdoors.
c) Avoid unintentional starting. Be sure switch is off before plugging in. Do not carry tools with
your finger on the switch or plug in tools that have the switch turned on.
d) Form the habit of checking to see that keys and adjusting wrenches are removed from the
tool before turning it on. A wrench or a key that is left attached to a rotating part of the tool
may result in personal injury.
e) Do not overreach. Keep proper footing and balance at all times. Proper footing and balance
enables better control of the tool in any situation.
f) Use safety equipment. Always wear protective glasses. Also use a face or dust mask if
cutting operation is dusty.
English
English FT3000 Manual.indd 4 English FT3000 Manual.indd 4 10/18/06 11:57:24 AM 10/18/06 11:57:24 AM