Connector #2 – Firstech, LLC. COMPUSTAR CM3000 User Manual
Page 3

Firstech, LLC. Technical Data (CM3000)
3
Connector #2:
Pin #1: Green/White- This is the low voltage (-) parking light output
200mA. Some newer vehicles require a (-) parking light output instead of
the standard (+) output (reference connector #1) such as the new Jeeps
and even some Fords.
Pin #2: Black- This is the (-) Status Out wire. It provides you with a (-)
200mA output as soon as the remote start is activated. This is the
sequence:
1. Remote Start unit receives signal to activate
2. At that time the Status becomes active providing the (-) 200mA
trigger
3. The ignition will activate and the car will start.
This is the wire you would connect to a Transponder Module or maybe a
VATS module.
Pin #3: Green- This wire is the (-) 2
nd
ignition 200mA output. You may
connect this wire to the purple pigtail of the additional relay on CN #1.
This will result in a (+) trigger output for the 2
nd
ignition on the blue wire
of the same relay.
Pin #4: White/Black- This wire is the (-) 2
nd
Accessory 200mA output.
You may connect this wire to the purple pigtail of the additional relay on
CN #1. This will result in a (+) trigger output for the 2
nd
accessory on the
blue wire of the same relay.
Pin #5: Red/Black- This wire is a (-) 2
nd
Starter 200mA output.
Normally the only vehicle this would be used on Nissan’s and older
Ford’s. You may connect this wire to the purple pigtail of the additional
relay on CN #1. This will result in a (+) trigger output for the 2
nd
starter
on the blue wire of the same relay.