FUJITSU P42HCA10 - Manual (Page 21)

E-21
• Setting Picture Mode (Picture Mode)
Can set up the picture mode.
Each time you press or , one of the available choices appears in the following sequence:
Dynamic: Suitable for watching a normal motion picture.(Standard)
Real:
Makes a strong contrast picture.
Static: Suitable for watching a still picture.
Press to store.
* Select Dynamic, Real or Static to suit your taste.
• Setting Luminance (Luminance)
Luminance can be set.
Use or to select a value between 40 and 100.
Press to store.
* Settings can only be done when the Picture Mode is Static.
• Adjusting Color Temperature (Color Temp.)
Use or to specify a desired color temperature. Each time you press or , one of the
available choices appears in the following sequence:
–3500: More reddish colors
Standard: Standard color temperature
+3500:
More bluish colors
User: User Color Temp. setup
Press to store.
• Setting User Color Temp. (User Color Temp.)
Can set up when User is selected in Color Temp.
Press
or to select Red, Green or Blue and press or to make adjustment in the range
of 0 to 255.
Press
to store.
* Color Temp. setup is switched to User. The initial value of User Color Temp. is adjusted
individually at the factory.
* On-screen information disappears if you do not take any action for about 60 seconds.
User Color Temp.adjustment screen
English
• Contrast, brightness, color darkness, tint, and picture sharpness are adjusted as shown in the following chart.
Select the item with , and then adjust with . Finally, press to implement the adjustments.
Adjustment Item Adjustment Range/Remarks
Contrast Lower contrast Higher contrast –30 to +30
Brightness Darker screen Brighter screen –60 to +60
Color Lighter colors Darker colors –60 to +60
Tint More purplish colors More greenish colors –60 to +60 (RGB)
–30 to +30 (Video, S-video)
Sharpness Softer pictures Sharper pictures –4 to +4 (RGB)
–16 to +16 (other than RGB)
02.12.3, 10:38 Page 21