Furuno MFDBB - Manual (Page 2)

2
Chart Plotter
Creating a route
3D display
Placing a point at cursor location Going to cursor position
Point marked
on chart plotter
POINTS
ROUTE
D
Position
cursor. CURSOR
PT 0001
GO TO
LIST
Select
location. CURSOR
Cursor position
set as destination
POINTS
ROUTE
CURSOR
+
Place cursor
on 1st point
of route.
Long push
Drag cursor
to next point.
Mark point.
Place remaining points.
Save route.
Tip!
If you marked a point
at the wrong position
press to undo.
CANCEL
CURSOR
CURSOR
CURSOR
CURSOR
CURSOR
Long push to
activate or deactive.
Adjust
pitch. Confirm
setting.
SHIP
3D
SCR
OLLING
Rotate
picture.
Confirm
setting.
* This procedure is available when 3D/Pan Tilt
Mode in the Chart-General menu is active.