beautypg.com

Solutions to common problems, Before you call – FRIGIDAIRE 241540101 User Manual

Page 36

background image

36

Solutions To Common Problems

BEFORE YOU CALL...

If you experience a problem with your refrigerator or notice a product behavior or
condition you do not understand, you can usually avoid a call to your service
representative by referring to this section for an answer. Beginning with the
following table, this information includes common problems, causes, and
suggested solutions.

Running Your Refrigerator

Problem Cause

Correction

Compressor does not run.

• Cooling system is turned Off.

• Refrigerator is in defrost cycle.


• Plug at wall outlet is disconnected.
• House fuse blown or tripped circuit

breaker.

• Power outage.

• Turn cooling system On. See page 15 for location of

cooling system On/Off button.

• This is normal for a fully automatic defrost

refrigerator. The defrost cycle occurs periodically,
lasting about 30 minutes.

• Ensure plug is tightly pushed into outlet.
• Check/replace fuse with a 15 amp time-delay fuse.

Reset circuit breaker.

• Check house lights. Call local Electric Company.

Refrigerator runs too much

or too long.

• Room or outside weather is hot.

• Refrigerator has recently been

disconnected for a period of time.

• Automatic ice maker is operating.

• Doors are opened too frequently or

too long.

• Refrigerator/freezer door may be

slightly open.

• Freezer control is set too cold

(control found in fresh food section).

• Fresh food/freezer gasket is dirty,

worn, cracked, or poorly fitted.

• It’s normal for the refrigerator to work longer under

these conditions.

• It takes 8-12 hours for the refrigerator to cool down

completely.

• Ice maker operation causes refrigerator to run

slightly more.

• Warm air entering the refrigerator causes it to run

more. Open doors less often.

• Ensure refrigerator is level. Keep food and

containers from blocking door. See Problem section

Opening/ Closing of Doors/ Drawers.

• Set freezer control to warmer setting until refrigerator

temperature is satisfactory. Allow 24 hours for
temperature to stabilize.

• Clean or change gasket. Leaks in door seal will

cause refrigerator to run longer in order to maintain

desired temperatures.

Compressor does not run.

• Electronic control system keeps the

refrigerator at a constant

temperature.

• This is normal. Refrigerator goes on and off to keep

temperature constant.

Digital temperature displays

are flashing.

• Electronic control system has

detected a performance problem.

• Call your Electrolux service representative, who can

interpret any messages or number codes flashing on

the digital displays.