Fisher-Price JEEP 72607 - Manual (Page 5)

• Lower the vehicle body.
• Fit a bushing, narrow side down, onto the exposed end
of the "A" front axle and into the hole in the vehicle
body.
• Fit a cap nut onto the end of the "A" front axle.
• Fit a cap nut tool over the cap nut and tap the center
with a hammer until the cap nut is secure.
• Repeat assembly steps and to assemble the
"B" front axle to the side of the vehicle body marked "B".
• Dispose of the cap nut tools properly.
8 9
Assembly
9
Cap Nut
Cap Nut Tool
"A"
Front
Axle
Bushing
Vehicle Body
• Position the handle over the rear of the vehicle body so
that it leans away from the vehicle body.
• While keeping the vehicle body stationary, insert and
snap the handle into the two holes in the rear of the
vehicle body.
10
Hole
Rear of
Vehicle
Body
Hole
Handle
5
• Make sure the areas where the labels will be applied
are clean and dry.
• Apply the labels as shown in the illustrations.
• For best adhesion, try to avoid applying a label more
than once.
One-time assembly is now complete.
1 2
10 9
7 8
3 4
6 5
Front View
Back View
Bushing