Furuno CSH-7 - Manual (Page 23)

3-4
Displaying menu-1, menu-2, system menu
1. Press the TX switch to blink the lamp (transmitter off state)
above it, if it is not already blinking.
2. Press the MENU key. The last-used menu among Menu-1,
Menu-2, and System appears. The menu below is Menu-1.
** MENU - 1 ** (RANGE SW: U/D GAIN SW: L/R)
DISPLAY MODE
TX OUTPUT
PULSELENGTH
TX CYCLE
TVG NEAR
TVG FAR
AGC
NOISE LIM
VP
IR
HOR BEAM ANGL
RES COLOR CURVE
COL EMPHASIS
FUNC1 PROG
FUNC2 PROG
USER PROG
DEGAUSS
AUTO DEGAUSS
MENU MODE : MENU - 1 MENU - 2 SYSTEM
: NORM
: 8
: 8
: 10
: 6
: 7
: 0
: 0 GPS
: 0
: 0
: WIDE
: LINEAR
: 1 (LOW)
: USER1
: USER2
: USER1
: EXEC
: OFF
TEXT
NARROW
1
2
SETUP1
SETUP1
USER2
TIMER
2
3
SETUP2
SETUP2
GYRO
3
4 (HIGH)
SETUP3
SETUP3
#
#
#
Requires INTERFACE Board.
# Locked setting
Figure 3-2 Menu-1
3. Operate the RANGE control to select item. The selected item
is highlighted in green and current setting in white.
4. Operate the GAIN control to change setting.
Note: Items in red are locked.
5. Press the MENU key to register selections and close the menu.
Menu-1 description