FujiFilm Yakumo DVD Travelle - Manual (Page 15)

Page 11 of 35 pages
YAKUMO DVD TRAVELLER 8.0 ENGLISH
BASIC OPERATIONS
PAL-NTSC Selection
To set up the MULTIMEDIA PLAYER according to the connected TV-set or TFT LCD monitor
and video signal system, to play a DVD or any other video discs, follow these guidelines:
z If your TV-set is NTSC, press the N/P button on the Remote Control until you see NTSC
on your screen.
z If your TV-set is PAL, select PAL by pressing the N/P button on the Remote Contro until
you see PAL on your screen:
z If your TV-set supports both PAL and NTSC, select MULTI by pressing the N/P button
until you see MULTI on your screen.
Disc loading
• Load
one
disc with the label side facing upwards and make sure you do not touch the
data side with your fingers.
• Slide the OPEN button on the MULTIMEDIA PLAYER to the left to open the lid for
loading or unloading a disc.
● Finger prints and dust on the disc surface can affect the sound and picture quality. Clean the discs regularly
with a soft cotton cloth from the disc center to the outside of the disc. Do not clean in circular motions.
● Do not use any kind of solvent, such as diluting agent, gasoline, liquid detergent, and gasoline liquid
detergent antistatic aerosol used for vinyl, this may cause serious disc damage.
● Keep discs away from direct sunlight or any heat source
● The MULTIMEDIA PLAYER is a precision device. If the optical pick-up lens and disc drive parts become dirty
or worn down, picture quality will become poor. To obtain a clear picture, regular inspection and maintenance
are recommended every 1,000 hours of use, depending on the operating environment.
● Zanon is not responsible for damage that may occur to any disc that is operated in this unit or not handled,
cleaned, or stored as suggested above.
Once the disc is loaded, the unit will automatically start reading the disk and it will take a few
seconds to download the disc initial data, thereafter the disc type will be displayed in the left
upper corner of the screen and the unit will start playing the disc.
3
Note:
● Do not touch the content side of a disc
● Do not stick any paper or stickers on a disc.
● Do not force the disc in place, it is possible you
damage the disc or the unit itself, if a disc is not
placed correctly on the guides in the disc tray.
● Use only the OPEN slide switch to open the lid, do
not use any other sharp objects, such as
screwdrivers, to force the lid open.
OPEN