FRIGIDAIRE 154575701 - Manual (Page 15)

15
CARE AND CLEANING
Cleaning the Spray Arm
The spray arm may need to be cleaned to insure that
there are no clogs to the spray arm jets and bearings
due to hard water chemicals.
To remove spray arm simply hold the spray arm in place
and turn the retaining nut clockwise
and pull up on the
spray arm lifting off the shaft.
To clean the spray arm use warm soapy water using a
soft brush to clean the jets and bearings.
To replace the spray arm simply set the spray arm on
the shaft, take the retaining nut and turn it counter
clockwise till it has locked into place.
A dishwasher left in an unheated place should be
protected from freezing. Have a qualified person do the
following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at the
supply source by removing fuses or tripping circuit
breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect water
line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water
into pan.
To Restore Service:
1. Reconnect the water, drain, and electrical power
supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher through
a POTS & PANS cycle.
4. Check connections to make sure they do not leak.
Property Damage Hazard
Freezing temperatures may cause water lines to
rupture. Be sure all supply lines to and circulating lines
within dishwasher are protected.
Failure to do so could result in property damage.
CAUTION
See Installation Instructions for more details.
NOTE
See Installation Instructions for more details.
NOTE
Winterizing