FUJITSU T4020 - Manual (Page 6)

6
L i f e B o o k T S e r i e s T a b l e t P C
Serial ATA Port 0 Submenu of the Main Menu
The Serial ATA Port 0 submenu identifies what Serial
ATA/IDE devices are installed. Note that actual hard drive label shown may vary.
Depending on the drive type, information such as cylin-
ders, heads and sectors may also be displayed.
Figure 2. Serial ATA Port 0 Master Submenu
Menu Field Options Default Description
Type: ■ Auto
■ None
[Auto] Select Auto to have the type of Serial or Parallel ATA device automatically identified
by the BIOS at POST. If None is selected, the following Set-up items do not appear.
LBA Format Logical Block Addressing (LBA)
Total Sectors: --- --- The total number of sectors on your hard disk
Maximum Capacity: --- --- The maximum capacity of your hard disk
■ A bootable CD-ROM or DVD-ROM may have a floppy disk or hard drive format. When a bootable CD-ROM or
DVD-ROM is used, drive allocations change automatically without changing the BIOS setup. If a floppy disk for-
mat CD-ROM or DVD-ROM is used, the disc becomes Drive A. The CD-ROM or DVD-ROM will only take drive
C: (hard drive format) if the internal hard drive is not present or is disabled. The bootable CD-ROM or DVD-ROM
can never use a C: designation if a formatted internal hard drive is present since the C: designator is always
reserved for the internal hard drive.The boot sequence ignores the new drive designations, however, your applica-
tion software will use the new designations.
■ Be careful of the operating environment when booting from CD-ROM?DVD-ROM or you may mistakenly over-
write files.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space
Enter
F9 Setup Defaults
F10 Save and Exit
Change Values
Select Sub-Menu
Main
Item Specific Help
Select Serial ATA/IDE
drive installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
[None]
The drive is disabled.
Serial ATA Port 0 [FUJITSU MHT2040BH-SATA]
Type: [ Auto ]
LBA Format
Total Sectors: 78140160
Maximum Capacity: 40008MB
▲