FMI ES401 - Manual (Page 5)

www.fmiproducts.com 122638-01E 5
Figure 3 - Heater Locations
CAUTION: Do not expose the
heater to the elements (such as
rain, etc.)
CAUTION: Wear gloves and
safety glasses for protection
during installation and main-
tenance.
This electric fireplace can be installed in a
mantel, framed into a wall or installed into an
existing fireplace. If installing into a mantel,
follow mantel’s assembly instructions.
LoCATINg FIREPLACE
Continued
Figure 3 illustrates a variety of ways the heater
may be located in a room. The heater may
be installed directly on the floor or raised on
a hearth.
INSTALLATIoN
WARNING - RISK OF FIRE!
The power cord must not be
pinched or against a sharp edge.
Secure cord to avoid tripping or
snagging to reduce the risk of fire,
electric shock or personal injury.
Do not run cord under carpeting.
Do not cover cord with throw rugs,
runners or the like. Arrange cord
away from traffic areas and where
it will not be tripped over.
WARNING - RISK OF FIRE!
To prevent a possible fire, do
not block air intake or exhaust
in any manner. Do not use on
soft surfaces where openings
may become blocked.
WARNING - RISK OF FIRE!
Do not blow or place insulation
against the firebox.
WARNING: If the informa-
tion in these instructions is
not followed exactly, a fire or
explosion may result causing
property damage, personal in-
jury or death.
Do not store or use gasoline or
other flammable vapors in the vi-
cinity of this or any other heater.
INSTALLING FIREPLACE
Select a suitable location that is not suscep-
tible to moisture and is a safe distance from
drapes, furniture and high traffic areas.
Note: Follow all national and local electrical
codes. This insert can be installed into either
an existing fireplace or as new construction/
renovation.
Installing in Mantel
1. Assemble mantel according to mantel
instructions.
2. Locate mantel near a wall (or corner
depending on mantel type) close to a
power source. You may have to alter base
boards to fit mantel flush against wall.
3. Connect fireplace to power source. Insert
fireplace into front of mantel. Be careful not
to scratch finish on base. Fireplace will fit
flush against front of mantel.
4. Push mantel with fireplace into final location.
Existing Fireplace Installation
1. Thoroughly clean out existing fireplace
and hearth area.
2. Seal all drafts, vents or ash clean-outs
with fiberglass insulation. Seal flue. Once
sealed, close damper to stop debris from
falling onto unit.
3. If existing fire box is susceptible to mois-
ture, cap top of chimney flue to prevent
infiltration of water.
Corner Mantel
Installation
Wall Mantel
Installation
Framed
Into Wall
or Existing
Fireplace