Cleaning, Replacing the batteries – Fluke 922 User Manual
Page 28
922
Users Manual
20
Cleaning
Clean only with soap and water. Remove any residue afterwards.
Periodically wipe the case with a damp cloth and mild detergent.
Do not use abrasives or solvents.
Replacing the Batteries
When the low battery symbol appears (
B
) the meter will not save samples and “bAtt”
appears on the display when
I
is pressed.
The Meter uses four AA batteries (supplied). To replace the batteries, do the following (see
Figure 5):
1.
Turn off the Meter.
2.
Remove the holster.
3.
Place the Meter face down on a nonabrasive surface and loosen the battery door
screw with a Phillips screwdriver.
4.
Lift the battery access door away from the Meter.
5.
Replace the batteries as shown in Figure 5. Observe the battery polarity shown in the
battery compartment.
6.
Secure the battery access door back in position with the screw.
7.
Reinstall the Holster.